FAQ  | E911  |  Contact us



Devices:


Contact us for devices not listed here.

contact page


Grandstream BudgeTone 101 and 102 Configuration

This is a full featured SIP desktop IP phone with a single ethernet interface. This means that you will need an open ethernet port on your local network. It has a built in speakerphone. It is fairly simple to setup. The default configuration will get an IP address via DHCP. The full manual can be found on Grandstream's Website.

NOTE: Do not try to use the '#' button to 'send' your calls, use the 'send' button instead. There are some instances where pressing '#' will not work as expected.

STEP 1
You must first determine what IP address the device received; to do this, press the menu button, then the down arrow next to it until the display shows:

[2] IP Addr

Now, press the menu button again and you will be shown the IP address of your device (e.g. 192.168.0.100)

STEP 2
You can use any browser on your computer connected to the same network as the device and enter the address: http://<IP ADDRESS>/
(where <IP ADDRESS> is replaced by the address that was given to you in STEP 1.

STEP 3
You will be prompted to enter a password, the default is "admin", then click the "Login" button.

STEP 4
There are quite a few parameters that must change. They are listed here:

SIP Server:
sip3.ip2pbx.net

SIP User ID: Enter the phone number you chose when you signed up for IP2PBX VoIP service.

Authenticate ID:
Enter the phone number you chose when you signed up for IP2PBX VoIP service.

Authenticate Password: Enter the password that you chose when you signed up for IP2PBX VoIP service.

Name:
Enter your full name. This will show up as part of your callerid.




SIP Registration: Yes



NAT Traversal: No



TFTP Server:
Change IP to 168.75.215.189



Voice Mail UserID: 8500
Send DTMF: via SIP INFO




STEP 5
Click on the "Update" button at the bottom of the form.



STEP 6
You will be brought to a confirmation screen on which you will click on the only option available: "Click to view your changes".


STEP 7

Click on the "Reboot" button at the bottom of the form.



STEP 8
Make calls!

 


Copyright 2007© IP2PBX.COM All rights reserved.
Legal Notice